Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Temple City, CA
Chimney repair in Temple City usually starts with a crack. Most of the homes here were built between the 1940s and 1970s, and the exterior brick chimneys that came with them have now spent 50 to 80 years absorbing Southern California ground movement, dry-cycle shrinkage, and the occasional Santa Ana wind event. When we get called out for what a homeowner assumes is a simple sweep, what we often find instead is mortar joint failure along the outside of the stack, a cracked crown, or a clay tile liner that was never meant to handle decades of creosote. Sherwood Chimney Sweep handles that full spectrum, from preventive cleaning to structural repair, and we have served Temple City since 2017. Call (833) 589-8498 for a straightforward assessment.
Why Temple City Homes Are Different
Temple City is an older San Gabriel Valley bedroom community, and much of its housing stock reflects the post-WWII building wave that filled in the area around the original town core. These are predominantly single-story ranch and traditional tract homes on small lots, many with original brick masonry fireplaces and clay tile liners that have never been relined. That matters because those fireplaces were built for occasional decorative fires, not the sustained modern wood-burning use we now see every winter. The result is creosote glaze inside the flue and cracked firebox mortar becoming the norm rather than the exception.
The local climate compounds it. Hot, dry summers and mild, mostly rainless winters mean fireplaces sit idle for months at a stretch, then get loaded up during brief cold snaps. Each burn cycle adds a new layer of creosote on top of the old, and without a sweep between seasons, the accumulated deposits harden into a tar-like glaze that brushes alone will not remove. During dry Santa Ana wind periods, the spark risk from an unmaintained chimney becomes something homeowners in Temple City should think about seriously. Add in the fact that the city is largely built out and tightly regulated, and nearly every job we do here is servicing, sweeping, or repairing an existing chimney, not building a new one. We also notice that many Temple City homeowners want documentation, including photos and sweep certificates, whether for insurance purposes or to keep the resale file complete. We provide that on every job.
Styles & brands we work with
Our Main Temple City Services
Most calls we field from Temple City homeowners fall into two categories: the annual or seasonal chimney sweep, and dryer vent cleaning that has not been done since the appliance was installed. Both are fire-prevention work first and convenience second.
Chimney Sweep in Temple City
A thorough sweep in Temple City means more than running a brush up the flue. We inspect the firebox, damper, smoke shelf, and cap while we work, because the mid-century brick chimneys in this city tend to hide hairline fractures that only become visible once the soot is cleared away. Given how many of these fireplaces were built with clay tile liners and have never been relined, the sweep is also the moment we check for early-stage glaze and recommend the appropriate next step only if we can show you camera evidence. For a professional chimney sweep in Temple City, we bring the same trade-grade materials and same standard of inspection to every house. Chimney Sweep in Temple City
Dryer Vent Cleaning in Temple City
Lint buildup is the leading cause of household dryer fires, and in Temple City’s 1940s-to-1970s housing stock, many dryer vents run long, angled paths from interior laundry closets to exterior walls, sometimes under floors or through the roof. Every bend is a place where lint accumulates. We treat dryer vent cleaning as part of the same fire-prevention discipline as chimney sweeping, which means you do not need to find a second contractor for the job. Dryer Vent Cleaning in Temple City
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Temple City
Chimney repair in Temple City is rarely about a single dramatic failure. It is more often about decades of small stresses, repeated cycles of heat and cooling, and Southern California ground movement slowly opening hairline cracks in mortar joints, crowns, and flashing. By the time a homeowner notices water staining on the ceiling near the fireplace or a thin line of brown creosote weeping through the exterior brick, the chimney has usually been asking for attention for years. We do not recommend repairs without camera evidence, and we always tell you straight when something can safely wait.
That is the difference between a cleaning-only operation and a full-service chimney contractor capable of diagnosing and fixing crown cracks, spalling brick, mortar joint failure, and liner damage. It is one company for the full chimney system. Chimney Repair
Chimney Cap Installation
Signs you need it
You can hear or see birds, squirrels, or debris getting into the flue, or your existing cap is rusted, missing, or blew off entirely in a windstorm.
What it costs in Temple City
Expect to spend around $150 to $250 for a standard single-flue cap installation, depending on access and flue dimensions.
How we do it
We measure the flue opening, remove any old cap, clean and prepare the mounting surface, then secure and seal the new cap, confirming the mesh size will not restrict draft.
Chimney Cap Replacement
Signs you need it
The existing cap is rusted through, has broken mesh, or was installed incorrectly and is causing drafting problems or water entry.
What it costs in Temple City
Replacement averages $150 to $250 including removal of the old cap and installation of a new, correctly sized unit.
How we do it
We pull the old cap, inspect the flue tile underneath for damage, then install the new cap with mechanical fasteners and appropriate sealant.
Chimney Flashing Repair
Signs you need it
You see water staining on the ceiling near the fireplace after rain, or the existing flashing is pulling away, corroded, or patched with old sealant.
What it costs in Temple City
Flashing repair on a Temple City home typically runs $250 to $500, though the final figure depends on roof pitch and how much existing flashing must be cut out and replaced.
How we do it
We remove old sealant and damaged flashing, inspect the underlying roof deck for rot, then install and seal new step and counter flashing so water runs off cleanly.
What Chimney Repair Costs in Temple City
| Item | Typical range in Temple City |
|---|---|
| Chimney cap installation | $150 – $250 |
| Chimney cap replacement | $150 – $250 |
| Chimney flashing repair | $250 – $500 |
Do I really need a new liner, or can mine be repaired?
Not every cracked liner needs to be torn out. We offer HeatShield ceramic resurfacing, which restores deteriorating flue liners without a costly full replacement. We will only recommend it after a camera inspection shows it will hold.
How urgent is a cracked chimney crown in Temple City?
Water is the enemy. A cracked crown lets moisture into the masonry, and over time that leads to spalling brick and deeper structural problems. In Temple City’s dry climate, damage happens slowly, but it is cheaper to seal a crown early than rebuild a stack later. Call (833) 589-8498 for an exact quote.
Brands We Service in Temple City
We work with professional-trade chimney materials, not hardware-store substitutes. In Temple City, our repair and relining jobs draw on DuraFlex flexible liner systems, HeatShield ceramic flue sealant, and Copperfield chimney components, the same supply chain specified by certified chimney engineers. Stocking materials through established distributors means we are not waiting on unverified parts when your repair is scheduled. Our brands
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Temple City, CA
| Service | Typical range in Temple City |
|---|---|
| Chimney sweep (standard inspection included) | $180 – $340 |
| Chimney cap installation | $150 – $250 |
| Chimney cap replacement | $150 – $250 |
| Chimney flashing repair | $250 – $500 |
| Dryer vent cleaning | $90 – $180 |
| Level 2 camera inspection | $150 – $350 |
What pushes a price higher in Temple City is access. Steep roofs, tall stacks on post-war ranch homes with limited ladder placement, and second-floor chimneys all add time. We give you a flat price before the work starts, so you will not see surprise line items at the end.
Neighborhoods We Serve in Temple City
We work throughout Temple City, including the older core around Temple City Boulevard and Las Tunas Drive, the mid-century tracts near Live Oak Park, and the quieter residential streets off Rosemead Boulevard. Each area has its own mix of post-war brick chimneys and later ranch-style additions, but the common thread is age: most flues in this city are well past their first liner service life. Response time for most Temple City calls is within a few business days, with priority available as we head into the colder months.
- Temple City core (around Las Tunas and Temple City Boulevard)
- Area near Live Oak Park
- Residential streets off Rosemead Boulevard
- Homes near Cloverly Park
- Southern edge bordering Rosemead
Service Area – Cities Near Temple City
Sherwood Chimney Sweep serves Temple City and the surrounding San Gabriel Valley communities. Homeowners from North El Monte, CA, Rosemead, CA, San Gabriel, CA, and Arcadia, CA call us for the same reason Temple City residents do: the housing stock here shares an era, and the chimneys all face the same decades-long wear. If you are nearby and not sure whether we cover your street, call us.
Serving Temple City, CA — Our Local Coverage Area
We’re based in the Temple City area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Temple City
Most Temple City appointments are scheduled within three to five business days. During late fall and early winter, when cold snaps hit and everyone lights the first fire of the season, the calendar fills faster, so calling ahead of that first burn is the smart move.
Most routine sweeps, cap replacements, and flashing repairs do not require a permit. Structural rebuilds or major liner retrofits can trigger local building code review, and we will tell you upfront if your job needs to go through the city. We handle the documentation side for you.
Yes. Every sweep and repair includes a written condition report, and we provide photos and camera inspection records when requested. For Temple City homeowners preparing to sell, having a documented sweep and liner inspection in the file is a useful selling point, and we will make sure the paperwork is something you can hand to a buyer without a second thought.
If your fireplace has not been looked at in years, or you have never had your dryer vent cleaned, call Sherwood Chimney Sweep at (833) 589-8498 for a free estimate. We serve Temple City, CA and the surrounding San Gabriel Valley, and we will give you an honest answer on what your chimney needs now and what can wait.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Temple City Customers Say
"What sold me was that he told me what NOT to do. I was ready to spend a lot more than I needed to and he stopped me. Ended up costing about a third of what I'd budgeted."
— Norma Martinez"Creosote buildup was worse than I realized. He measured it, showed me the glazing on the flue with the camera, and was honest that we were closer to a chimney fire than I wanted to hear."
— Divya Rao"Fireplace had never drawn properly since we moved in. He found the damper was only opening halfway due to a bent linkage and fixed it in ten minutes."
— Diego Herrera